Force Super Performance Urethane CLEARCOAT W/MEDIUM ACTIVATOR 4:1

Description

SURFACE PREPARATION
: Apply basecoat per manufacturer's mixing and application instructions. Allow sufficient flash times before applying Clearcoat. Inadequate flash time will affect the performance of this product.
MIXING DIRECTIONS
: Ratio: 4:1 4 parts of 2354 Clearcoat, 1 part of hardener (MEDIUM). Stir thoroughly between each addition. Strain before spraying material.
DIRECTIONS FOR USE:
All drying times refer to shop temperature of 77°F (25°C) / 50% humidity. Allow additional drying time when optimal conditions are not reached.
SPRAY GUN AND PRESSURE:
Gun Type Tip Air Pressure
Siphon Feed 1.4-1.6mm 35-45 psi
Gravity Feed 1.2-1.6mm 25-40 psi
HVLP 1.2-1.6mm 10 psi
Apply 2 full wet coats allowing 10 to 15 minutes flash time between coats or as conditions dictate. Caution: Do not apply over non catalyzed acrylic or synthetic enamels or acrylic lacquer finishes.
DRYING TIMES:
Flash: 10 to 15 minutes Sanding: 3 to 6 hours
Buffing: 3 to 6 hours To Deliver: 3 to 4 hours
FORCE DRYING:
Let the last coat flash for 20 minutes before baking. Bake at 140ºF (60ºC) for 40 minutes. Clearcoat maybe wet sanded and buffed after 1 hour cool down time.
RECOATING:
Clearcoat may be recoated after a 24 hour period. Clear must be sanded before recoating.
FISH EYE:
The use of fish eye eliminator is not recommended.
POT LIFE:
3-4 hours @70ºF (21ºC)