1K Ready to Spray Non-Sanding Primer Sealer GALLON High Teck in 4 Colors

Description

HIGH TECK NON-SANDING PRIMER/SeALER GALLON
National Rule Product
High Teck 1K Primer/Sealer is an excellent quality, low build phenolic modified alkyd.
1K Primer/ Sealer is fast drying can create a uniform surface without a lot of film build.
1K Primer/Sealer provides excellent adhesion to fully cured painted surfaces, treated and primed steel, properly prepared aluminum and fiberglass.
1K Primer/Sealer may be topcoated with a variety of topcoats such as basecoat, lacquer or enamel
Gallons
come in 4 different colors  Black, Gray, Red, White
Surface Preparation
Solvent wash surface with a good grade wax and grease remover and wipe dry with a clean cloth. Sand original paint and repair damaged areas with a good quality non-staining body filler. For spot repairs, scuff sand area where sealer will be applied. For overall refinishing, scuff sand the entire car with 320 grit sandpaper or fine scuff pad. Apply one to two single wet coats of 1K Primer/Sealer to achieve the uniform color desired.
Mixing Directions
Sealer is Ready to Spray
Application
Adjust air pressure at the gun to 30-45 psi for siphon feed guns. Use less pressure to minimize over spray on small jobs. Apply 1-2 medium wet coats at a gun distance of 8-12 inches as needed. Allow 5 to 15 minutes flash time between coats. Recoat times will vary with temperature, air movement and film thickness. Insufficient flash time will promote slow hardness development of the topcoat system. Allow final coat to dry 30 minutes to 1 hour before topcoat. Must be top coated with-in 12 hours after that scuff or sand before top coating. Recommended Film Thickness: 1.0 to 2.0 mils
Dry Times
Dry times are based on recommended film thickness and are dependent on ambient temperature. Excessive film thicknesses, low temperature and poor air movement will retard dry times